- Is replicatorg windows 10 compatible driver#
- Is replicatorg windows 10 compatible manual#
- Is replicatorg windows 10 compatible archive#
- Is replicatorg windows 10 compatible software#
Tighten the thumb screws on the underside of the build platform to make sure the platform does not hit the extruder nozzle/heads. An automatic setup script will be displayed on the LCD display, press the middle 'M' soft key to continue. The first run experience steps below tunes and sets up the build platform and extruder. Is replicatorg windows 10 compatible software#
Lastly, flip the power switch to power up the bot and and skip to the next section to perform the software calibration. Find, or use the supplied US, power cord and plug it into the adapter and the other end to the four pin socket on the Replicator. Unpack the filament spools and put them onto the support with the filament pointing from the bottom and up towards the center of the backpanel, cut the bent end using a plier and feed them through the guides till they hit the extruder. Hook the spool supports to the back of the MakerBot, with the top tap going in upwards. Press the black filament guide tubes onto the extruder holders and clip the guides in place on the back. Refit the heated build platform cable below the platform to the bottom plate, adjust position of the cable to limit slack. Add the rubber feet to the side panels under the bot to dampen the vibrations and increase friction on the MakerBot's working surface. In the accessories box, find the two black hex screws and fasten the extruder (the washers are for the extruder plunger maintenance). Move the build platform up by pulling on both of the inner back supports of the build platform to remove the cardboard piece and the two filament spools. Slide out the large accessories box and open it to take out the extruder and place it on the extruder platform. Is replicatorg windows 10 compatible manual#
Open and remove the top large cardboard piece along with the user manual and take the entire Replicator out of the box. The basic setup of the MakerBot replicator is quite simple, below is a compressed version of the official guide. MakerBot Replicator v5.5 machine information - system information and default print profile. Is replicatorg windows 10 compatible archive#
MakerBot SD card August 2012 - zip archive of the included SD card.
Is replicatorg windows 10 compatible driver#
Controller: Allegro A4982 DMOS Microstepping Driver.E - see the MakerBot Replicator Upgrades page RGB LED driver: PCA9533 4-bit I2C-bus LED dimmer.Stock filament: black and natural white (yellow).This was a gift for helping the team out with graphics illustrations. Overall dimensions: 320 x 467 x 381 millimeters or 12.6 x 18.4 x 15 inches.Works with ABS, PLA, and other materials.Universal Power Supply - 100-240V, 50/60Hz, 4.0A (input), and takes standard IEC cable.4x20 LCD character display and multi-directional control pad.5 axis, 1/16 micro-stepping motor control.MakerBot MightyBoard single-piece motherboard.Positioning precision: 2.5 micron on Z axis 11 micron on XY axes.Maximum temperature for heated build platform: 120 C.Maximum recommended extruder temperature: 230 C.With a build envelope that's roughly the size of a loaf of bread, it gives you the power to go big, and with the new MakerBot Stepstruder MK8, built-in Dualstrusion is possible for the first time. The Replicator is MakerBot's newest and best yet personal 3D printer. This is the technical specificatiosn provided when it was first introduced 19.
0 kommentar(er)
